This cookie is set by GDPR Cookie Consent plugin. The cookies is used to store the user consent for the cookies in the category "Necessary". The cookie is set by GDPR cookie consent to record the user consent for the cookies in the category "Functional". The cookie is used to store the user consent for the cookies in the category "Analytics". These cookies ensure basic functionalities and security features of the website, anonymously. Necessary cookies are absolutely essential for the website to function properly. i didn’t even use a wire, I just push the header pin right in, as close to the trace as possible, and solder them together. finally solder a tiny piece of tinned tiny wire (30 awg or 28 awg) to connect the trace to a header pin or something.put solder flux on the trace, and tin it.You can repair this by using a knife to scrape and expose the trace for that pin/solder pad.Luckily enough I was able to repair mine! Although I don’t know how reliable it is going to be, at least it seems to work for now. In fact the RC pins are all very important for the Naze board, they all have their own jobs, and not interchangeable at the moment:ĭon’t apply too much heat on solder pads for too long, and don’t apply ANY force to them while soldering / de-soldering. (because I am using UART2 on RC3 and RC4 pins) As I primarily run PPM, and it’s currently not possible to do PPM apart from RC1 pin (as far as I know), it pretty much means I had to run PWM, or ditch the board and get a new one. I pulled the RC1 and Radio 5V solder pads off my brand new Naze32 board when I was removing the pre-soldered pins.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. Archives
January 2023
Categories |